Morin Concealed Fastener Series N-12

N-12 from the Concealed Fastener (CF) Series is produced with a common side joint affording the designer the option of a mix and match concept with other Morin profiles.

Concealed fastener design. Common joint design allowing multiple panel integration. Panels may be installed vertically, horizontally, or in combination.
Production: Lengths 5' (1.52m) to 30' (9.14m) standard Shorter and longer lengths available
Application: Weather-resistant or rainscreen rear-ventilated application
Materials: Galvalume/Zincalume Painted Steel: 18 thru 24 GA Aluminum: 0.050 GA and 0.040 GA Stainless Steel: 20 GA, 22 GA and 24 GA Zinc: 1.2mm, 1.0mm and 0.8mm Natural Copper: 20 oz. and 16 oz.
Color: Standard (Fluropon® PVDF-Kynar500®) Premium Colors MICA (Fluropon Classic®II PVDF) Premium Colors METALLIC (Fluropon Classic®PVDF) Morin Custom Color Matching Services Other Finishes Available
Surfaces: Smooth surface standard; Stucco embossed texture optional. Optional Ribs are also available for additional strength and visual continuity on wider panels.


Sealant: Optional factory sealant available
Substrate: Open framing or other various backup wall assemblies (i.e. ext. sheathing, air/water barrier, exterior insulation)
Clips: Negative Pressure Clip: Individual Clip, Galvalume: Supply quantity as needed, no full carton requirements; Individual Clip S/S (used on copper and S/S panels): Supply quantity as needed; Continuous Clip, Galvalume: 10'-0" long Formed Trim
Corners: Mitered Seamed Corners 2'-0"x 2'-0" 90° Minimum 70° (closed) Maximum 135° (open) outside or inside Max. length of leg 6'-0" long Perforated to be cut and bent only - No glue
Notched Ends: Folded ends: Available option. Notch and fold both ends of panels (Consult inside sales office)
Testing: Air Infiltration: ASTM E283 Water Penetration: ASTM E331 Dynamic Water Penetration: AAMA 501 Structural Performance: ASTM E330 and E1592 Impact Testing-Florida Product Approvals: ASTM E1996/ E1886; TAS204
Mfg Facilities: Bristol, CT, Fontana, CA and DeLand, FL

The information contained in this MORIN Technical Specication Sheet (TSS) and any accompanying typical detail sheets is reliable and correct, but is subject to change without notice. Typical details are meant to show the products of the seller in a manner which is representative of the way in which they are installed. It is the responsibility of the buyer or his or her architect or engineer to verify that any product is suitable for the conditions and use intended and that the products are compatible with a any other material.

Printed October 31, 2020, 09:02 pm